SOURCE: installing new brake pads on 2000 hyundai Accent GL
REMOVAL
1.
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
2.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION
1.
Check the pads for wear or oil contamination and replace, if necessary.
•
The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets.
•
All four pads must be replaced as a complete set.
•
When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material.
2.
Check the pad for damage or deformation.
Brake pad thickness:
Standard value: 9 mm (0.354 in.)
Service limited value: 2 mm (0.0787 in.)
INSTALLATION
1.
Install the pad clips.
2.
Install the pads onto each pad clip.
3.
Insert the piston in the cylinder using the Special Tool (09581-11000).
4.
Install the new pads. The shims are attached to each pad as illustrated
Be careful so that the disc or pad isn't contaminated by grease.
5.
Install the bolt and tighten to the specified value.
Tightening torque
Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
SOURCE: hyundai accent, location of fuel cut off
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
SOURCE: Location of NSS(neutral safety switch) on 2002 Dodge Caravan
It is in side the trans on top of the valve body. Why do you think you need to replace it?
SOURCE: 2002 Hyundai Accent GL error code P0442, EVAP
You have a vacuum leak. This means that you will need to go through all of the vacuum likes and make sure they are connected and not broken. If they are broken buy new vacuum line, its like less and $1 per foot. In your case if you can I would replace all of the vacuum lines if they look cracked and old.
SOURCE: what wires do I need
The wires on the Transmission Range Sensor that control the ability to crank the starter are the BLACK/GREEN wire at Pin 6 and the wire at Pin 10 which is either BLACK/GREEN or BLACK WHITE depending on your model. (build - date and transmission type)
With all that said, I think it only fair to warn you that bypassing these wires will set codes in your Engine Control Module. It is not going to like it if there is power at pin 10 with the transmission in reverse or any of the forward gears. This may also cause your transmission to not shift properly because the ECM will not know for sure what gear you are in.
Testimonial: "thanks so much for the information I will install a switch and only use it when needed and to ensure that this is my problem."
161 views
Usually answered in minutes!
×