Srs code 44

You already asked this question, and it was answered pretty accurately previously. Here is the Volvo bulletin on this SRS (airbag) fault code.

Look at the two pin connector under the passenger seat. Remove the center console and checked the SRS control module plug . Measure the resistance between pin 37 & 38 of the control module and 1 & 2 of the plug under the seat.


Code: SRS-013D Definition: Left SIPS Bag. Faulty Signal Description: Diagnostic trouble code (DTC) SRS-013D is stored if the control module registers that the resistance is too high in the ignition circuit. The SRS indicator lamp is lit. Cause:

• Open-circuit in the cable or contact resistance in the connectors between the SIPS airbag and the SRS control module.
• Open-circuit in the SIPS airbag (resistance too low in the igniter).

Get the trouble codes read for the SRS system and then you'll have a starting point. No way to guess what the code is

Right primary crash sensor is loose or hanging by its wires

SRS - that's for air bag, need to have diag. done on air bag system. to fine out what part of it is not working right, auto parts like autozone can pull code's on it for free, get back with us with the code number, so we can help you diag. your trouble code.

What is SRS code 27 D-PT SQ Trouble 2

code 13 is Oxygen Sensor Circuit No signal to computer

Until you get the trouble codes read there's no way to know what's causing the fault. So not, there's no easy fix without the codes

Trouble Code 44 indicates that the O2 sensor is showing a persistently high exhaust oxygen content (lean), despite the efforts of the ECM to increase ...
Code 42 : Electronic spark timing (EST) circuit fault

Code 33 is MAF sensor (mass airflow sensor ) & 44 is lean exhaust mixture. My guess is 33 is causing 44.

Hey, The SRS mean " Suplement Restrain System"

Or Air Bag System.

If you have the SRS light, you have problem with the Air bag system. and need to take codes to see what happen or what is damaged.
Honda 2000 Accord come with a yellow connector behind of the Instrument panel fuse box. That is used to take manual codes from the SRS computer.. to see the problem.

I hope this respond your question,

Thank's