2005 crank position sensor location on a chrysler town and country van

Sure the new coil is working? Did you check for spark?Is the fuel pump working? Fuel injectors? ECM?

Did you mean thermostat in Engine Cooling Water

The crank sensor will be located on the back of that engine. By the starter. YouTube has a cool video about it.

if you go to your local dodge dealer they will show you how to use it

when looking at the left hand side of the engine ( from the front or belt side ) it would usually be down on the block to the side of the crankshaft damper pulley and 4-5 inches back from the front of the engine.

I have same issue on my 2003 TC - 3.8L Van. Do you have a picture of the CPS location?

its the positive wire that goes to the fuse box from the battery. its crimped into the main positive wire. it needs a better connection.

Ohhh this is a difficult one. The crankshaft is not easy to replace in any vehicle, and vans can be harder.

At least the drive belt is in the front of the motor. You'll have to jack up the front of the vehicle and safely support it on jackstands, the crankshaft sensor is located behind behind the crankshaft sensor on the bottom of the serpentine belt. The Belt has to come off, then the crankshaft pulley has to come off, in order to get at the sensor.



Because they may involve removing part of the air conditioning system to get to it, a seriously suggest seeing a mechanic so have the A/C system professional discharged, before continuing.

Here is the location...not knowing your engine size.....









And this is the two type of crank sensors...visuals to help you locate yours:

Hello melvin453: My name is Roger and I will help you. The crank position sensor is located on the rear of the transmission housing above the differential housing. The bottom of the sensor is located next to the drive plate (flywheel). Should you need further help please just ask.Please rate the answer. This way i know it was helpful. Thank You for using Fix Ya.