Wont start
Wells Jeep/Chrysler Ignition Switch Replacement LS711 LS922 ...
https://www.youtube.com > watch
I had the same problem but I just went to where I bought my car and they fixed it . Here's a way you can do it yourself if you can:)
SOURCE: JEEP WONT START
Sound like a connection (loos of the ground circuit) problem to the in tank fuel pump, I wouls suggest you check all the connections from the fire wall back for any loose or corroded connectors.
SOURCE: 2.5 jeep wangler 1999 wont start .starter checks out ok
Could be a bad connection between the battery and starter. Starter solenoid, or neutral safety switch if it is standard transmission.
Check for power at the solenoid.
Lone99star
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Testimonial: "Will try! Thanks!"
SOURCE: 2000 jeep wrangler will not start from the key
It sounds like you have a bad neutral safety switch or your linkage is worn enough that it's not registering properly.
SOURCE: 1999 jeep wangler blower good new switch new
Did you replace the bloer motor also, usually a resistor failure is caused by a failing blower motor. here is a diagram to help with diagnosis, Make sure you have voltage at the blower motor connector with the key on. If not verify the fuses and the blower motor relay shown in the diagram. If voltage is present diagnose the ground side. The ground path goes from the motor, through the resistor, through the selector switch, then to the ground listed in the diagram.nosis.
466 views
Usually answered in minutes!
×