1995 Subaru Legacy Logo
Kayla Blackwell
Kayla Blackwell Posted on Jun 19, 2014
Answered

JUST DID A HEADGASKET JOB ON MY 95 SUBARU LEGACY, GET EVERYTHING BACK TOGETHER NO SPARK?

BOUGHT NEW PARTS LISTED IGNITION MODULE $206 IGNITION COIL PACK$113 CRANK AND CAM SENSOR $99.99 NGK R PLATINUM PLUGS AND WIRES $63 IM THINKING VALVES ARE OUT WHEN I TOOK MY CAM BOLTS OUT WITH IMPACT MAYBE ABY SUGGESGTIONs??? pls help

Answer This Question

1 Answer

jon murray

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 3 Answers
  • Posted on Jun 19, 2014
jon murray
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: Jul 11, 2013
Answers
3
Questions
0
Helped
430
Points
5

Sounds like a timing problem, did you replace the cambelt? or check the idlers for wear? a worn idler could make it jump.

5 Related Answers

Anonymous

  • 141 Answers
  • Posted on Jan 20, 2009

SOURCE: 90 Subaru Legacy with no spark

Have you checked the ignition fuses, or checked for power to your ignition module? You have everything else covered! I hope these ideas will get you running. Best wishes.

Ad

Anonymous

  • 4 Answers
  • Posted on Sep 14, 2009

SOURCE: Subaru Legacy Wagon 4WD engine does not fire up

take a look to the timing belt, it may be broken. hope it help

Anonymous

  • 8 Answers
  • Posted on Jun 26, 2009

SOURCE: Subaru Legacy LS 4WD won't fire

timing belt broke most likley

Anonymous

  • 1608 Answers
  • Posted on Dec 01, 2009

SOURCE: Coil pack only firing on front two cylinders on my

Did you try an ignition module?This could be your problem.Make sure you have good compression.

Anonymous

  • 1 Answer
  • Posted on Nov 04, 2010

SOURCE: 95 subaru legacy car no spark to front two

Did you correct the problem?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2.2 l subaru wont start
Coil or ignition module may have failed.
Read full answer
Jun 24, 2014 • 1991 Subaru Legacy
2helpful
1answer

95 subaru legacy car no spark to front two cylinders after new coil pack
Did you correct the problem?
Read full answer
Oct 17, 2010 • 1995 Subaru Legacy
0helpful
1answer

I was driving my 1991 subaru legacy and it just died. It still turns over and is not out of gas but it won't start back up. I assume it is a fuel or spark problem but I am not very familiar with fuel...
either an ignition module or a sensor on a vehicle this old ,think the sensor might be inside the distributor on this one,and the module under the coil
Read full answer
Aug 28, 2010 • 1991 Subaru Legacy
0helpful
1answer

Weak throttle response 92 subaru legacy
I would have have the TPS (Throttle Position Switch) tested, it sends a signal to the ECM of where the position of the throttle is so the ECM can determine how much fuel and air and spark to give to the engine. Have you replaced the spark plugs, fuel filter, air filter, spark plug wires? Have the coil tested also to see if it is putting out enough spark. Do you have any Check Engine Light coming on?
Read full answer
Jun 03, 2010 • 1992 Subaru Legacy
1helpful
1answer

Coil pack only firing on front two cylinders on my 1990 subaru legacy LS 4wd replaced coil pack, spark plugs, wires, and still has same problem.
Did you try an ignition module?This could be your problem.Make sure you have good compression.
Read full answer
Dec 01, 2009 • Subaru Legacy Cars & Trucks
3helpful
2answers

I have a 19992 Subaru Brumby which loses ignition spark
its quite possibly the crank angle sensor as they do this when they heat up,the car wont start,till it cools down,you can get the resistance checked on it to see if its ok,but you will need someone with experience to do it but its not a hard job
Read full answer
Nov 11, 2009 • 1993 Subaru Legacy
0helpful
1answer

Subaru Legacy Wagon 4WD engine does not fire up
take a look to the timing belt, it may be broken. hope it help
Read full answer
Sep 14, 2009 • 1995 Subaru Legacy
2helpful
2answers

Where is the ignition control module located on a 1990 Subaru legacy 2.2l
Center of firewall. It is a black plastic box with 2 screws or e the ignition module could be mounted below the steering column.
Read full answer
Jul 04, 2009 • Subaru Legacy Cars & Trucks
0helpful
1answer

Subaru Legacy LS 4WD won't fire
timing belt broke most likley
Read full answer
Mar 19, 2009 • 1990 Subaru Legacy
0helpful
1answer

90 Subaru Legacy with no spark
Have you checked the ignition fuses, or checked for power to your ignition module? You have everything else covered! I hope these ideas will get you running. Best wishes.
Read full answer
Jan 20, 2009 • 1993 Subaru Legacy
Not finding what you are looking for?

View Most Popular

1995 Legacy

  • Cars & Trucks

Related Question

2.2 l subaru wont start

  • 1991 Subaru Legacy

Related Topics

213 views

Ask a Question

Usually answered in minutes!

Popular Questions

1999 Subaru Legacy Sedan.. speedometer works

1999 Subaru Legacy

How to remove starter motor-Subaru Legacy

1998 Subaru Legacy

Security light flashes and it won't start

1996 Subaru Legacy

1997 subaru outback legacy overheating

1997 Subaru Legacy

Where is the vehicle speed sensor for the 2004 subaru legacy located

2005 Subaru Legacy

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...