SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1
It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.
SOURCE: HOW DO YOU REPLACE A STARTER FOR 1991 CHEVY LUMINA
1) Disconnect cable from negative battery terminal
2) Raise vehicle front and suitably and safely support.
3) Remove cover from starter wiring (small right angle-like black plastic cover).
3) Loosen large wiring harness (underneath starter) so that it can be moved out of the way.
4) Remove outer nut and wires from solenoid.
5) Remove outer nut and wires wires from starter.
6) Remove two (2) screws retaining plastic flywheel cover and cover.
You will need to do this - otherwise you will be unable to remove the
front bolt holding the starter to the engine block. This cover is a
small black plstic piece located where starter penertates the flywheel
cover.
7) Remove (2) bolts retaining starter to the engine block. One
is accessable towards the front of the starter/vehicile and the other
(long one) is towards the rear of the vehicle - just behind the frame
cross member.
8) Position starter so that if can be dropped down (flywheel gear part first).
9) Reverse the above instructions to install the new starter/solenoid
SOURCE: how to remove a starter on 1993 chevy lumina?
Support the car very securely first of all
Remove the negative cable from the battery
Remove the wires from the starter
Remove the two bolts from the starter going upward to the engine block
Wiggle the starter out
Reverse this proceedure to reinstall
REMOVAL AND INSTALLATION
3.1L Engine
Besides regular hand tools, a special oil pressure sensor socket will be necessary to complete this operation.
129 views
Usually answered in minutes!
×