Run flat indicator reset - 2006 Mercedes-Benz CLS-Class

Needs resetting on mb star at dealers

Follow these simple steps to reset the BMW TPMS without the iDrive system:

1. Check all tyre pressures are set to the manufacturer's recommended settings.
2. Use the indicator stalk to scroll down until you see the tyre symbol and 'RESET'
3. Press the BC button on the end of the indicator stalk.
4. The display with show 'RESETTING'

might need a scanner

If you have enough pressure and the light still on, then you have a bad sensor, take it to the dealer and they will replace the bad sensor

Press the menu option on the steering wheel till you get to the temperature. press the up or down key until you get to see 'Run Flat: Active'. Then press the reset key (the key near the steering wheel to reset counter) that should do the job.

Yes u have

you may need to reset the tpi for the system to work.
TPI tire pressure indicators.

Ok this is very easy to do :
1- Switch ignition on. 2- make sure the standard display menu appears in the multifunction display. 3- Press button down or up repeatedly until the following message appears in the multifunction display
RUN FLAT INDICATOR
ACTIVE
REACTIVATION POSS.: +

4- Press "+" 5- The following message will appear in the display
TIRE PRESSURE OK NOW?

6- To confirm activation press "+" 7- The following message will appear in the display
RUN FLAT INDICATOR
REACTIVATED

8- Wait till "TIRE PRESSURE OK NOW?" disappears
You are done
Hope this helps

use the I drive system to reset flat tire monitor, go to vehicle settings, then flat tire monitor, then select reset, then you have to drive the car system resets as you drive

Using the indicator stalk, navigate to the tyre pressure reset option, press the reset button twice in short succession but hold it in the second time until a tick appears on the display