SOURCE: where does the fuel filter go on the 1997 jeep
You may have one along frame rail near rear wheel area on drivers side.
SOURCE: replace fuel filter on 1997 jeep grand cherokee
If you have the V8 engine, the filter is actually part of the fuel pump. WHICH IS IN THE TANK
SOURCE: 2003 Jeep Vacuum Diagram
THERE SHOULD BE A EVAP/VACUUM DIAGRAM UNDER THE HOOD ON A WHITE STICKER. SOMETIMES THEY ARE ON THE BOTTOM SIDE OF THE HOOD ITSELF. I HOPE THIS HELPS. PLEASE KEEP ME POSTED THANKS FOR USING FIX-YA AND FOR AN HONEST RATING/COMMENT. GOOD LUCK
SOURCE: how to change the fuel filter on a 2003 grand jeep
The Fuel Filter/Fuel Pressure Regulator is combinated component in your Jeep; this is remotely mounted to the vehicle body, above the rear axle and near the front of the fuel tank (Fig 25 & 26 of the Repair Manual).
Check the WJ Service Manual Section-14-Fuel-System-Ewj14 (page 15 and next).
Hope helps with this (remember rated this help) Good luck.
SOURCE: location of cam sensor 2003 jeep grand cherokee v8
Answer
pic
REMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).
It is easier to remove/install sensor from under vehicle.
Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.
See picture for sensor location.
Testimonial: "that is just what i needed thanks"
76 views
Usually answered in minutes!
×