2004 lincoln ls v8 pvc where?
SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION
it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.
SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...
First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)
SOURCE: diagram for a 2000 lincoln ls V8
Your best ,to cut the old belt,to remove.
You can use a long handle 1/2" drive ratchet, on the belt tensioner.
The only pic is in the shop manual.
Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.
Draw a picture before you start, and you won't need a diagram
SOURCE: where is the coil pack located on lincoln ls v8 7
Driver side valve cover
7mm socket to remove coil covers and coil
1 thru 4 pass side
5 thru 8 drivers side
Front to back
SOURCE: engine diagram showing location of crank sensor on
Hi, be sure to oil the o-ring and twist the new sensor as you push it in.. Please let me know if you have more questions, and thanks for using FixYa.
1,048 views
Usually answered in minutes!
×