What is abs code c0036 - 1997 Chevrolet C1500

https://www.google.com/search?q=2008+buick+lacrosse+code+c0121

Yes, this says 'ignition voltage', even though the code is C0036, it does state that the ABS uses 12 volts system voltage.

C0036 BUICK Code Left Front Wheel Speed Sensor Circuit ...https://www.autocodes.com > c0036_buick
May 2, 2018 - The Wheel Speed Sensor (WSS) receives ignition voltage from the Electronic Brake Control Module (EBCM) and provides a DC square wave signal back ...

..

ABS code C1145 - Ford Truck Enthusiasts Forums

www.ford-trucks.com > ... > 1997 - 2003 F150

Aug 20, 2009 - ABS code C1145 1997 - 2003 F150. ... C1220 Yellow ABS WarningIndicator Failure (2) C1222 Wheel Speed ... C1230 Rear ABS Sensor (Electrical/Static) (2) ... ABS light on (Anti Lock Brakes) and I hear pump when in turn ...
Oct 9, 2010
ABS code C1206-2003 F150 SuperCrew
Aug 13, 2007
ABS light C1230
Oct 22, 2006
ABS light on DTC's C1229,C1230
Nov 18, 2002
More results from www.ford-trucks.com

Definition of Diagnostic Trouble Code U2108 Buick: CAN Bus Error ABS Cadillac: CAN Bus Error ABS Chevrolet: CAN Bus Error ABS GMC: CAN Bus Error ABS Oldsmobile: CAN Bus Error ABS Pontiac: CAN Bus Error ABS Saturn: CAN Bus Error ABS


Definition of Diagnostic Trouble Code P0722 Category: Powertrain Definition: Output Speed Sensor Circuit No SignalNote: This definition of P0722 is applied to all manufacturers

hi, you need to identify make model and year of your vehicle

The ABS EBCM anti-lock brake module is failing causing problems with the ABS pump running constantly, also will drain your battery.

1. Remove the ABS fuse to prevent ABS motor burn out.
2. You can still drive your vehicle with the module removed.
3. We recommend covering the exposed surface of the hydraulic control unit with aluminum foil to keep out water and dirt.

Common Failures:

• ABS Pump Always Running
• Codes: C0265, C0267, C0268
• Pump Motor Circuit trouble code
• Power Relay trouble code
• Valve Relay Trouble code
• Dump Valves (solenoids) trouble codes
• No Communication
• Intermediate power loss

http://www.myairbags.com/dtc-code-c0265-abs-ebcm-light/

Have a qualified brake shop check this out ASAP>

I agree that it is more then like the the hub bearing assembly that also houses the speed sensor I would first check that there is no damage to the wiring that goes to the hub bearing that could be easy repaired, or debri that has been caked in between the sensor & the hub, use an air preesure to clean it out. Hub bearings are very expensive, so try this first. Good luck

It is part of the bearing hub assembly.Very have to do without air tools,If setting multiple abs/tc code (wheel speed sensors) probably abs electronic module or chaffed wires on drivers side at ac lines by air box.Have big problems with this and probably will come back.

Sounds like you need front wheel speed sensors. Replace the wheel bearings and sensors. May have an ABS unit fault, but more likely is both wheel bearings/speed sensors.