Question about 2002 Jeep Liberty
Hi. My 2003 Jeep Cherokee (Liberty in the States?) has an air con problem. It doesn't blow cold. Just had it recharged with refrigerent. The heater blower works & dashboard fuse is OK. The engine speed does increase slightly when the heater control dial is moved to air con mode, as if it was under load, but no cold air. There's a big fuse thingy in the fuse box under the bonnet - can this be checked? I couldn't even get it out. I hope it isn't an expensive problem! Thanks in advance, Richard (UK)
You most likely have a problem with a part called the air temperature control blend door, it controls the air flow across the AC core or heater core, it is most likely warped or the motor that operates it is defective or in most cases both are in need of replacing. This repair requires the entire dash be removed to access the AC parts.
Posted on May 18, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
it maybe a blend door problem. if both hoses at the firewall for the heater are close in temperature its not likely a heater core. the actuator for the blend door is located on the bottom of the heater/ac box towards the middle of the bottom. it will be a tight fit but you can remove it without removing any part of the dash. take it off and disconnect the power. start the vehicle and manually move the door and see if the temp changes
Posted on Jan 11, 2009
It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.
Posted on Feb 01, 2009
. Open the gloves compartment (gc) . remove 2 rubber pieces that keep the gc on its place (both sides) . look to the left side. there is a connector with a few thin colored hoses. This thin hoses are there to control the operation of the blend air door. It is vacuum operated. . now follow the thinnest hose, probably it is green, all the way to the right. It connects in a sort of vacuum valve that control the position of the blend air door. make sure it is firmly attached to it. also check that hoses connector to ensure that all thin hoses are well connected. . OK! start the motor and operate the knob on the panel. It should work fine now.
Posted on Dec 16, 2009
go to this site it will have exactly what your looking for. a diagram and a list of what everything is.
Posted on Apr 24, 2010
Testimonial: "thank you very much!! i solve my problem... thank's"
Sounds like low speed coil in the Blower Fan resistor block has failed. The Blower Fan Resistor Block is usually located in the air ducting adjacent to the Blower Fan. The Resistor Block consists of 3 or 4 coils of special resistance wire attached to terminals which connect to the wiring that comes from the fan switch and then to the Blower Fan. The block is on the output side of the fan unit so that the airflow from the fan past the coils inside the duct assists in preventing them from overheating and burning out.
Access to the Resistor Block is from under the dash. To replace, remove the multi-pin connector and then undo the screws holding in the block. Check air duct for leaves and dirt which may have caused the coils to fail. .Replacement is the reverse procedure
Posted on Nov 27, 2010
Tips for a great answer:
Nov 18, 2017 | Jeep Cars & Trucks
Oct 10, 2016 | Jeep Cars & Trucks
Dec 05, 2011 | 2003 Jeep Liberty
Jan 21, 2011 | 2003 Jeep Liberty
Aug 30, 2010 | 2003 Jeep Liberty
Mar 24, 2010 | 2003 Jeep Liberty
Mar 02, 2010 | 2003 Jeep Liberty
Dec 21, 2008 | 2003 Jeep Liberty
395 people viewed this question
Usually answered in minutes!