Question about 1991 Jeep Wrangler

Open Question

1991 5 speed 2.5 4x4 i turn the key power comes on but will not start,i have to try a few times before it starts.

Not hearing any noise from starter trying to start

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Ronnie Houston

  • 2920 Answers

SOURCE: 1998 cheeroke sport --replaced starter

check the crankshaft sensor....its not the starter relay if its turning over

Posted on Jan 20, 2009

Ad
rockitman187

Randy Hough

  • 2559 Answers

SOURCE: my 91 jeep won't start...

The Starter relay is bad.

Posted on May 05, 2009

Anonymous

  • 5 Answers

SOURCE: 1996 Jeep Grand Cherokee Laredo starter

This means it is the solenoid. But usually on those the starter and solenoid are one unit. They can be purchased individually, but it is usually almost as expensive as replacing the whole unit.

Posted on Aug 23, 2009

Richard Scordino

  • 6982 Answers

SOURCE: 2006 Jeep Wrangler won't start

First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.

Posted on Oct 02, 2009

Testimonial: "Will try! Thanks!"

Anonymous

  • 149 Answers

SOURCE: 2007 jeep wrangler tip start feature problem

yes, sounds like the starter solinoid whent out, if it shorts out it can stay running, it must be replaced ,there is no quick fix, if its a manual trans you can push start it. i dont know of any internet tips.

Posted on Oct 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Difficult to start (hear noise) turn the key few times and starts


- For starting problem check the following:
- Battery (perform battery test with battery tester).
- Check battery terminals for any corrosion and sulfate deposits.
- Battery to starter motor cable.
- Battery to engine ground and chassis cable.
- Starter relay and solenoid.
- Starter motor.
- Ignition switch.
- Wiring and connectors.
- Alternator.

Mar 02, 2014 | Cars & Trucks

1 Answer

99 voyager starting problems


Your ignition switch is going bad. The strange noise is the starter remaining engaged and locked to the flywheel. Your best bet is to have the starter tested at your local auto parts store, to deduce that it is not, in fact, your starter.

Nov 05, 2013 | 1999 Plymouth Voyager

1 Answer

I have 2003 model, 5-speed maual transmission. Had trouble starting engine a few times in last cople of days. Thought I didn't push clutch in all the way. Started after a couple of tries. Eventually...


If there is no "clicking noises" at all first you have to bypass the Clutch Start Switch. To do so remove two wires from the Start Switch and connect them together.
If it doesn't work trouble shoot starter and solenoid. With a wire connected to (+) terminal of the battery power up the solenoid, at the thin wire contact of the starter. You need another person to help you, in the cabin turning the ignition key in ON and start position. If starter and solenoid are O.K this will start your car. If not you have to replace the starter + solenoid assembly. Good Luck.
Sam from,
American Car Co.
862b0b2.gif

Oct 31, 2010 | 2003 Toyota Tacoma

3 Answers

Starting difficulty. When I turn the ignition


Check your battery terminals and the hot lead on the starter make sure they are clean and tight. If they are you are most likely will need a starter.

Feb 14, 2010 | 1991 Toyota Pickup

1 Answer

96 Firebird Formula, 5.7 LT-1, 6-speed manual starter problem


Starter Have a friend turn the key to the start position while you tap the starter with a hammer. If the starter is going bad but has not completely failed most of the time it will start when you tap on it.
Ignition switch If the key turnes easily and lights, radio, etc. come on when it is in the on position I don't think it is the switch. Plus if the starter has never been replaced I'd say the chance that is the problem is very high.

Feb 11, 2010 | 1996 Pontiac Firebird

4 Answers

2006 Jeep Wrangler won't start


First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.

Oct 01, 2009 | 2006 Jeep Wrangler

2 Answers

Won't start...99 cadillac deville...no juice to the starter


hi, can you hear a clicking noise when you turn the key to start as the starter gets its power direct from the battery so also check these wires are connected and not came loose.
If you can hear a clicking noise when you turn the key this means the starter motor needs replacing ok.
Let me know how you get on or if you need further assistance ok

Aug 10, 2009 | 1999 Cadillac DeVille

1 Answer

1991 jeep cherokee laredo won't start


you can test your signal wire to the starter by having someone turn the key to start while you put a test light on the signal wire at the stater.If there is no signal on the light then there is a problem with the sending wire from the ignition.

Mar 07, 2009 | 1991 Jeep Cherokee Limited

4 Answers

2003 Chevy Cavalier not starting


When you turn the key, you should hear the fuel pump make a whiring noise as it dispenses the fuel. If there is no noise. the fuel pump is not working.

Have you checked the fuel shutoff inertia switch.?
Check your owners manual for location.

Dec 16, 2008 | 2004 Chevrolet Cavalier

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...