SOURCE: Brake Light
hi from uk to change the brake light bulb/s on the getz is easy just open rear hatch then you will see 3x pozi drive screws alongside each lamp assy that screw /secure the lamp to body at the lower endof drain channel? remove screws and lift away lamp from body each bulb is accessable then now would be a good opportunity to clean the area at rear of lamp ? then reassemble is reverse as above my wife has one of these cars and has been absalutely trouble free for past 5yrs but it does get lots of tlc/servicing by myself hope the instructions are ok to follow?
SOURCE: High Level Brake bulb replacement
If memory serves, there are two screws holding this light assy to the rear package deck. They are covered (LH and RH side of this assy). remove the covers and using a phillips screwdriver, remove the screws and lift the assy up and away from the rear glass. you now have access to the bulb and socket.
SOURCE: removing rear wheel hub on hyundai getz 1.3
if you mean the drum then hit it in the front between the lugs should jar it loose. give it a good wack
SOURCE: how to replace the front brake pads on a hyundai
Instead of explaining in words, here you find the right link to understand the disc barking system & how to relace the worn out pads.The link refers elantra, but the basic remains same for the GETZ.
http://www.cockeyed.com/lessons/brakeshoes/brakeshoes01.shtml
110 views
Usually answered in minutes!
×