How do I replace a fog light - 2003 Subaru Outback

Hi Lois,here's a video to replace your fog light, Fog Light Replacement 2000 2005 Dodge Neon 2001 Dodge Neon 2 0L 4 Cyl

Its all attached by clips and screws.Nothing much special.But its all about the procedure.Dont forget the mark the position , location of the screws you remove, so while refitting you don't face any problemTo replace fog light bulb or to replace replace complete fog light unit, click this link below:--- http://technoanswers.blogspot.com/2011/07/how-to-replace-left-front-fog-light.html ---------- This will help.Thanks.Helpmech.

underneath the offending fog light there is an access panel. its held closed with two 10mm bolts. take out the two bolts and reach inside for the fog light. there is a tab you must press inward to turn the the socket. turn the fog light socket and remove it from the fog light housing. replace the bulb, and reverse the steps for reassembly.

There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose.

REPLACE THE FOG LAMP SWITCH DOWN ON THE STEERING COLM. REMOVE THE PROTEC. PANEL UNDER STEERING COLM. AND GENTLY START TO LOWER THE COLM. WATCH OUT FOR THE SHIFT IND. WIRE- REMOVE IT- LOWER COLM. AND HALF WAH DOWN ON THE TOP SIDE IS THE SWITCH FOR THE FOG LAMP CONTROL IF YOU HAVE ALREADY REPLACED THE ELEC. SWITCH - (PUSH BUTTON OR ROCKER STYLE ).IN THE DASH. IF - - LIGHTS AREON AND THE FOG LAMPS ARE TURNED ON AND THE HEAD LIGHT GO OUT OR WONT CHANGE FROM DIM TO BRIGHT REPLACE HIGH/LOW SWITCH ON COLM. SAME PROCEDURE AS FOG CONTOL SWITCH.

hi..You will have to access the fog light bulb from below the vehicle.
Remove the plastic clips from the wheel well cover extension that is
below the fog light.once the clips are out and the plastic cover is pull
down,you should be able to see the back of the fog light.you can try
to replace the fog light bulb by removing the two 10mm bolts and slide
the fog light assemble out through the front of the bumper.Turn the cover
of the rear of the fog light and replace light.
try this out..
thank u..
kindly rate my response..

Sounds like your multifunction switch (i.e. the stalk that has the fog light switch) has burned out. This is a fairly common problem and the multifunction switch needs to be replaced.

The part (as I recall) costs < $100 (about 80, I think) and takes less than half an hour to replace.

you need to take off the buttom shields and then you should be able to get to the fog lights

hi disconnect your fog light switch if this doesn,t knock them off you need to find the fog lights relay and replace it as the fog light circuit is shorted best of luck yates210456

Answer is on Bavarian Auto web site:
3 Series 92 to 98 Fog Light Replacement-
To install a fog light, insert a flat blade screwdriver through the front bumper grill and release the fog light retaining clip. Remove the fog light and disconnect the wiring harness. Installation is the reverse of removal.

http://www.bavauto.com/shop.asp#e36fog