Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jun 09, 2014

My key fob on my 2002 mini cooper wont unlock the doors even though the led light lights up

Tried everything holding buttons putting in ignition four times still nothing

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jul 09, 2009

SOURCE: e39 starting issues

HAVE YOU HAD THE BATTERY TESTED? ARE THE BATTERY TERMINALS/CABLES CLEAN AND FREE OF CORROSION? ARE THEY TIGHT?

Ad

Anonymous

  • 11 Answers
  • Posted on Aug 03, 2009

SOURCE: 2000 Toyota Corolla wont start Changed 02 sensor disconnected bat

Check your alarm. because the alarm system has a engine immobilizer which makes the engine do what you are experiencing. Take the car to the dealer and tell them what is going on and they will reset the car system.

Larry Chandler

  • 1149 Answers
  • Posted on Feb 09, 2010

SOURCE: The front passenger door lock does not pop up, or

Hi:
You didn't mention the year of your vehicle, but often when the electric door lock solenoid fails, it becomes siezed in place, where it is un-moveable. This causes the condition that you are experiencing. One way to check to see if this is the cause, is to remove the drivers inside door panel and disconnect the door lock solenoid, and verify the manual key lock works ok.

Anonymous

  • 140 Answers
  • Posted on Apr 07, 2010

SOURCE: Key fob works windows and entry lights as well as

.G'day mate this seems to be a power to the central looking probem ,things to check first are fus, actually pull it out and make sure it is in sound condition, then go to the door jamb and see that the harness is not crimped /broken ( if the switch is in the door ) other than that take to the repair shop as these are quite complex vehicles electrically, hope this helps

choprboz5

  • 197 Answers
  • Posted on Jun 01, 2010

SOURCE: lights keep going dim on mini cooper s 2007 dashboard

You don't say if it's "just" the dash lights, or if other lights do it as well. Try turning on a dome light and see if the dome light does it along with the dash lights. Do you notice your headlights doing this as well? These are just troubleshooting steps. If multiple light sources (dome, headlight, etc.) do it, then it's most likely a voltage regulator issue.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

How to program fob for 2011 chevy malibu

google how to program fob for 2011 chevy malibu for more info

On the Chevy key fob, press and hold the "Unlock" and "Lock" buttons at the same time until you hear the door lock and unlock again. This means you're all set. Re-insert the programmed key back into the ignition to the "On" position to finish the Chevy key fob programming process
0helpful
1answer

Key fob dont work, but door lock works ok, key fob battery change.

1. Get in your vehicle.
2. Close the door.
3. Put key in ignition
4. Do not turn on the ignition yet.
5. Hold down on the unlock button on the door panel. Do not let up.
6. Turn the key to ON, OFF, ON, OFF (while still holding the unlock button on the door panel).
7. Release the unlock button.
8. The door locks should cycle, indicating that you did everything correctly.
9. Have all your remote entry fobs available. Hold down on both the lock and unlock buttons until the door locks cycle. Do the same on all key fobs. This will re-program all of them.
10. Turn ON the ignition key to exit the program mode.
11. DONE.
0helpful
1answer

Cars key fob open doors

the chip in the fob could of come lose you would need to ope the fob up. it will start car as the key is chiped to. dropping the fob or banging it can make the chip losen off the board and will need soldering back on.
6helpful
1answer

My passenger door central locking has stopped

Method 1: Press lock or unlock button 4 times in succession. Method 2: Switch ignition ON and OFF. Within 10 seconds press lock and unlock button in succession.
This is the only manual reset
If this does not work go to your local auto electrician
The probable fault could be central locking activator passenger door
6helpful
4answers

My Porsche Key fob no longer unlocks the doors

Insert key into door barrel or ignition lock and turn key, whilst doing this press the unlock/lock button, the led on the dash should flash to indicate this has initialised the key to the car, then remove key and test operation of remote. If this fails then a new remote plus coding to the car by your dealership is needed
2helpful
1answer

Keyless entry wont work 2002 chevy s10 LS

try this procedure to reporgram:

1. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver's continue to hold down until instructed
to release in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the key to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the vehicle locks and unlocks.
This step may take up to 30 seconds.

11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode
3helpful
3answers

TWO KEY FOB IS NOT WORKING ONLY ONE

Have all keys with you inside the car and repeat again with the second key within 30 seconds...... "Press and hold the 'unlock' button while at the same time pressing the center 'lock' button three times. On the third time, release the 'lock' button at the same time you release the 'unlock' button." If you have a key with three buttons, ensure doors are unlocked. Put key in ignition and turn key over to 2d position where dash lights, etc come on. Pull key out. Press and hold the "unlock" button while at the same time pressing the center "lock" button three times. On the third time, release the "lock" button at the same time you release the "unlock" button
1helpful
1answer

Mini cooper key fob settings

Try pushing the unlock button twice.

Mechanic @ Large Mobile Automotive Service Tucson,AZ
www.mechanic-at-large.com
Not finding what you are looking for?

178 views

Ask a Question

Usually answered in minutes!

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...