What are the torque specs for the subframe on a 06 vic police car

SOURCE: Replace horn on 2006 crown vic

I believe once you have mounted the horn and connected the wire you will find that the horn wire was cut at (by) the steering coloum that the siren override was hooked to,you will have reconnect this,I hope this helps you

SOURCE: 2003 Crown Victoria: lost my only key to my 2003 police cron vic....

not to sound crazy ! do u own this car out rite! if so you can go to the dealer with the reg and they can cut u a key through the vin number! the key will cost 30 to 45 dollars ! its cheaper than a locksmith

honeymokey

• 3113 Answers
• Posted on Dec 14, 2010

SOURCE: How do I know if

I suggest that you look this up and the term interceptor refers to police package as in heavy duty suspension,brakes transmission etc. http://en.wikipedia.org/wiki/Ford_Crown_Victoria_Police_Interceptor

SOURCE: My wipers are coming on

Hello, Its the Multifunction switch for the turn lever and wiper controls. The contact points are usually corroded or loose and a bump can cause them to make contact. The usual solution is to replace the switch. Only a few styles are capable of being cleaned and disassembled.

You will need to remove the steering column cover. Usually requires moving tilt wheel several times to guide plastic cover out of place. There are 2 wiring harnesses attached to the control. They have flimsy latches and care needs to be taken when spreading the latches or they will break.
The switch has several torx head screws or in some cases Security screws holding the part to the column.

There are differences in the number of contact terminals in the switch. Some have 2 additional posts for other functions. Best to bring in old one to get correct part.

SOURCE: where is fuelpump on 2003 crown vic police intercepter

can you replace a fuel pump from a 2000 Crown Victoria with out removing the gas tank