How do you change tps on 2001 hyundai xg300? - 2001 Hyundai Elantra

SOURCE: hyundai 2001 XG300 tensioner pully adjustment

the belt that goes on the alt. ?? if so the tensioner is accessed from under neath the car. You will have to remove the right side tire and plastic sheild that is in place. When you look up at the bottom pulley you will see a nut head. If you lay on your back and look up at the engine, it will be located on the left or front side of the car.

SOURCE: XG300 Fuel Door Stuck!

I THINK THERE IS A STRING IN THE TRUNK ON WICHEVER SIDE THE FUEL DOOR IS AT

SOURCE: replacing 2001 Hyundai XG300 headlight, how difficult?

Here's a photo - remove cap, disconnect connector to bulb, move bulb retainer out of the way & extract bulb - installation of new bulb is in reverse order.
If you want to replace the entire ASSEMBLY, there are three (3) 10mm bolts holding the assy. Remove them, then slide assy forward to access connectors - disconnect them.

SOURCE: 2001 Hyundai XG300 with an engine light (p0715/P1159)

clean up all ground wires but you may need both of those items

SOURCE: how do i remove a belt from a 2001 hyundai xg300

Removal & Installation

1. Raise and support the vehicle.
   
2. Remove the engine splash shield.
   
3. Rotate the drive belt tensioner clockwise to release the drive belt tension.
   
4. Remove the drive belt from the alternator.
   
5. Slowly release the drive belt tensioner.
   
6. Remove the drive belt from the accessory drive pulleys.
   

To install:

1. Install the drive belt to the accessory drive pulley.
   
2. Rotate the drive belt tensioner clockwise.
   
3. Install the drive belt to the alternator.
   
4. Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
   
5. Slowly release the drive belt tensioner
   
6. Install the engine splash shield.
   
7. Lower the vehicle.
   

Accessory drive belt routing—1.5L engine


Accessory drive belt routing—2.0L engines


Accessory drive belt routing—2.4L engines


Accessory drive belt routing—2.5L and 2.7L engines


Accessory drive belt routing—3.0L and 3.5L engine