Would like to know what size the hub nut is on a 2003 ba falcon and why does it have the metal jacket around it? thankyou.
SOURCE: How to Remove the Rear Bumper - BA Fairmont/Falcon
Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.
SOURCE: my 2003 ba ute transmittion has problems, when in
check the codes but is likely the shift position sensor on trans
SOURCE: Just wondering if 2003 BA Falcons have cv joints
it will have both the cv joint is part of the axle and the balljoint is under the spindle
SOURCE: 1993 F150 4x4 w/ auto locking hubs - rotor removal
There are some special 4 tooth and hex sockets for removing the nuts inside the hubs of the truck.
YOu can find these at NAPA or maybe AutoZone or Advance. I would go to NAPA because they more than likely have it and also know something about repairing this assembly.
Ford uses Dana front end parts and NAPA has original Dana parts in stock... so it is as good as or better than original and they would have the tool for it.
Be careful and follow the procedure exactly for putting the front hubs back together.
YOU CAN RUIN THE FRONT END OF THE TRUCK IF YOU DO NOT PERFORM THIS SERVICE CORRECTLY.
And trust me... many of the idiots working in repair garages do not know how to do these older 4x4 hubs either... ask someone and read the books for the right procedure... some of the older mechanics may show you how to do it. Ask
SOURCE: ba falcon heater
Just had the same thing happen to my BA. No hot air. I'm a bit of a handyman so I had a go myself. 8 Hours is a reasonable estimate. You have to remove the steering column and entire dashboard to get the bugger out. Not a job I would attempt again.
1,838 views
Usually answered in minutes!
×