How do i stop the clutch from slipping in high gear, driving at about 60mph in 5th tried to excelerate but the speed stayed at 60 and the revs shot up, it is an intermitent fault but doesnt arrear to happen in low gears, i even tried pulling away in too high a gear to make the clutch slip but it just stalls as you would expect
If engine revs increase but road speed does not increase, your clutch is coming to the end of its life and needs to be replaced
SOURCE: manual trans wont slip into gear
sounds like a fluid leak. or low fluid check you fluid levels
SOURCE: car makes belt slipping noise
You need to tighten the belt or replace it.
Testimonial: "was good advice"
SOURCE: 2000 kia sportage clutch works sometimes
The master cylinder only gets low if there is a leak. Your slave cylinder or the master cylinder is leaking. Look under dash were the petal pushed the master cylinder to see if fluid is coming out. Then look at the slave cylinder under the car. It is bolted to the right side of the transmission bell housing. May have to pull rubber boot back on it to check for fluid leakage.
SOURCE: its an automatic 1st gear dosent work and 2nd gear
you need to check your owner manual and see what type of transmission fluid you use because it sounds as if its low give these websites a try www.alldatadiy.com and www.autozone.com if you have miss place your owner manual see if you can down low one at www.edmunds.com wish you the best of luck Michigan Man.
SOURCE: My kia sephia..the gears are
You need a new clutch. A 5 speed is a gear box , they dont slip like an automatic can.
223 views
Usually answered in minutes!
×