Where is the fuel fuse located on a 4cyc Jeep wrangler 1990
SOURCE: Jeep wrangler Fuse box
i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck
SOURCE: 1988 jeep wrangler no fuel
check your fuel pump relay and your ignition switch those numbers you gave for voltage are not right, please recheck that you have a ground and 12volts at the pump while cranking please rate -jeff
SOURCE: 4wd problem jeep wrangler yj 1995
i just bought a used 97 CHEROKEE but i had the same problem, when i got to looking at it i found out the front driveshaft was shot, look at that, if its not it i would say its probably the transfer case especially with an older vehicle like that which is a very expenxive repair
SOURCE: 1990 Jeep YJ 6 cyc. Won't Start---No Spark From Coil
It would be great if you could find the Ignition Control Module!!! From my experience on my Jeep...90 YJ 4.2 liter carb. it does not have one...Computer controlled only...
SOURCE: What does the auto shut off fuse do? 92 Jeep Wrangler.
The auto shutdown relay in your vehicle is controlled by the computer. If the computer does not see a signal from the crank or cam sensor, it will turn off power to the relay which in turn shuts off power to the fuel and ignition system. Unlike those in many passenger vehicles, it's not connected to an impact sensor. (as jeeps are off road vehicles as well as being transportation, if they had an impact sensor, they would be prone to shutdown when traveling over rough off road terrain)
The fuses to the relay are affected by shorting or overload of any components they serve, or by a problem with the relay itself.
357 views
Usually answered in minutes!
×