Also jumped terminals but no luck, having a check eng when warmed up: stumbles/choking when accelleratiom
SOURCE: Where is the diagnostic port
The ports are usually located on the driver side underneath the dash on the right near the center.
SOURCE: Stalling Toyota Camry 2004
P-0102 and P-0113 are mass air flow and intake air temp codes, the P-0136 is an Oxygen sensor code. Before you do anything, check for debris in the Mass Air Flow Sensor, it's small black box with electrical wiring connector that is screwed into the intake air tube, between the air box and the intake manifold. Undo the screws, remove the sensor, and, with a flashlight, and look down inside it for debeis, or broken wires inside it. If it's dirty, it could throw a P-0136...Comment back on what you find; hope this helps, and thanks for choosing FixYa!
SOURCE: 1995 Toyota Camry fuel problem. Engine turns over
Along with the fuze, there is also a relay in the system. If the relay is defective you will not have any power to the pump. Best to check for current at the pump connector (near or at the fuel tank) with either a test light or volt meter. If you have power, the pump is bad. if not, check the relay and retest.
Hope this helps
Testimonial: "Thanks"
SOURCE: 96 toyota camry changed from miles to kilometers on the odometer
yes there is a button you push it in and it changes from kilometers to odometer, should be in front of closter on the right side, right side of steering wheel.
SOURCE: HOW TO SET TIMING ON 96 TOYOTA CAMRY 2200 MOTOR
Click on the following free direct Link. It has the Timing: Pulley, Belt and Mark Diagrams for your 1996 Toyota Camry. Plus additional Instructional and Directional Diagrams.
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/1996/make/toyota/model/camry/1996_toyota_camry_timing_belt_diagram_marks.htm
136 views
Usually answered in minutes!
×