How do I remove the door panels froma 2003 jeep wrangler

Fuse 18 or 19

Fuse Box Diagram Jeep Wrangler (TJ; 1997-2006)

https://fuse-box.info > jeep > jeep-wrangler-tj-1997-20...
The fuse panel is located behind the glove box. The location of the fuses in the passenger compartment: Jeep Wrangler (TJ; 1997. To access ...

1997-2006 Jeep Wrangler TJ Fuse Box Diagram

https://knigaproavto.ru > shemy > 920-1997-2006-jeep...
Oct. 8, 2019 - Fuse Box Diagram Jeep Wrangler engine: 2.4L, 2.5L and 4.0L (TJ; 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006)

usually, door panels just pull off, but they make a special tool for door panel removal. check your local auto parts store for specifications.

jeep cherkee fuse panel is on thr right hand side front of engine bay that is near the battery good luck alan from dardanup w australia

To access the fuse panel the glove box must be removed. It is removed by slipping the glove box strap off the hook and letting the door roll down off its hinges. To reinstall, position the glove box door at an 8 o’clock orientation, engage the hinge hook formations on the lower edge of the glove box door with the hinge pins on the lower edge of the instrument panel. Tilt the upper edge of the glove box door upward toward the instrument panel enough to reattach the glove box strap to the door. Rotate glove box door to closed position. Open and close to insure proper installation.



Also can download the 2006 TJ Wrangler - Owners Manual

Hope helps (remember rated this). Good luck.

Inside handle, no, outside yes, to access nuts/bolts on back side.

assuming that this jeep has not been wrecked recently, the only way to get that door open is to remove the door panel while the door is closed, at least enough to reach the door latch inside the door, once reached you can operate it and release it to open the door, I will tell you that the likely hood of damage to the door panel will probably occur, I have had this problem before and I had to cut a hole in the panel reach in and open the door, sorry it can't be simpler. if you feel the latch operating and you have recently ran into something, try pull the door handle from inside while pushing the door open

to remove the door pannel there is 2 screws and then like everything ells on jeep there are little clips that you need to pull off, try removing the screws and then pulling from the interior pannel

I have a 2003 jeep sahara and experienced the same problem ..........with mine the lock mechanism was stiff and i had to remove the door panel and lube everything and work the locks and the release handles until they worked freely.
hope this helps!

you will need a t-20 or t-15 torx bit driver to remove 2 screws holding the handle this is all that holds them on, on once you have a replacement handle it is easier to remove 2 lower screws on the door panel and unsnap the door panel to loosen it this will allow space making it easier to reinstall new handle just slide each end into the slot and reinsert 2 screws to not fully tighten until door panel is snapped back in. the panel is held on with clips and can be released using plastic pry tool around door panel edges.