Dawoo leganza 1999 2.2ltr where does injector pulse come from ?

If you have diagnosed the vehicle to have no fire, does it have injector pulse? Fuel pressure? Does the check engine light come on during a bulb check? Have you looked at the crank sensor? This sensor supplies info to the computer to start/control ignition spark

no injector pulse - DodgeForum.com

dodgeforum.com/forum/2nd-gen-ram.../269362-no-injector-pulse.html
Nov 21, 2010 - no injector pulse 2nd Gen Ram Tech. ... but was running and driving fine before. as far as i can tell i have no injector pulse. tested with a noid ... No spark AND no fuel injector pulse ONLY when van is cold ...
Nov 18, 2013
2000 ram 1500 Has spark but no injector pulse wont start ...
Jun 25, 2013
v10 RAM no start....frustrated
Sep 19, 2011
help - no spark, no injector pulse, no run
Oct 30, 2009
More results from dodgeforum.com

No injector pulse 02 Ram 1500 - DodgeTalk : Dodge Car Forums ...

www.dodgetalk.com > ... > 3G Dodge RAM - General Talk
May 30, 2012 - No injector pulse 02 Ram 1500 3G Dodge RAM - General Talk

1991 this make you OBD1 . You can access a code by jumping 2 terminals together.The injector pulse is from the PCM . If you have no pulse you need to troubleshoot for spark first . If you dont have spark do spark first then injector pulse comes on. If no injector pulse check fuse in engine junction box.Use a volt meter check grounds at PCM. If all else checks out good replace PCM. You may also want to check the TPS. If this sensor short out in the WOT position you also wont get injector pulse.SO disconnect the TPS. and recheck for injector pulse

Daewoo tacuma wont hold on rev making tank noise

[Yes] it could be a fuse,have you checked them.

Check the timing belt which might be broken--if so, there will be severe valve and piston damage to cope with. If the belt is intact, then you may have a bad crankshaft or camshaft sensor, either of which will cause loss of ignition and injector action. Good luck!

the temp gauge sender unit on single cam is near no1 injector in inlet manifold.
on twin cam engines it under neath inlet manifold in head

plug1 = coil 1
plug2 = coil 4
plug3 = coil 3
plug4 = coil 2

here

try the code 1325 and see if it will unlock the radio