Chrysler 2004 pacifica start up and then shut off
SOURCE: Where is starter located on 2004 chrysler
Look around the "back" of the engine beside the transmission. The Starter connects to the flywheel to start the engine.
If you are replacing the starter you may want to consider doing this first;
) Have the charging system checked. Many auto parts stores and Sears will do this for free.
) Clean the battery terminal/connectors.
) Check the wiring from the battery to make sure it's good.
If you replace the starter yourself;
) Does your car have an anti-thief alarm ? If so find how to reset it if the battery is disconnected. Some alarms will shut down the car if the battery is disconnected !!
) DISCONNECT THE BATTERY.
) Disconnct the wiring to the starter.
) Remove the bolts holding the starter. Remove the harder one to reach first.
) Pull out the old starter.
) Put it the new starter.
) Bolt the new starter in. Put the easier bolt to reach first.
) Connect the wiring to the new starter.
) Re-connect the battery.
) If necessary reset the thief alarm.
) Take the old starter back for a core charge refund.
SOURCE: 2004 chrysler pacifica
It is for an oil change mainly and any other service your maintenance manual suggests at the mileage interval. It needs to be reset after each oil change to be accurate.
SOURCE: How do you replace the EGR valve on a 2004
check with you dealer, that part may have a manditory extended warranty by law
684 views
Usually answered in minutes!
×