SOURCE: wont start without starting fluid
Could it be a plug up injector , have sewiing needle , stick it in the sprayer part of the injector on the carberator part
SOURCE: 1990 ford f250 cranking not starting
Make sure it is getting gas; check the fuel filter and fuel pump and any fuel pump relays. If it is fuel injected make sure your getting current to the injectors and check the relay. You might also want to check the starter solenoid and your ignition wires, distributor, distributor cap, rotor, etc... You don't say if this problem occurred suddenly or if it's been an ongoing.
Testimonial: "all excellent points"
SOURCE: Would an 1990 ford f250 7.3L diesel , transmission
IF MY MEMORY SERVES ME RIGHT THE 5.0 IS A SMALL BLOCK AND THE 7.3 IS A BIG BLOCK. IF THIS IS THE CASE NO THE TRANY WON'T BOLT UP
SOURCE: 1979 ford f250 wont start unless i put gas in CARB
first of all you have no carb its fuel injected, at least you know you have spark, now do you have fuel pressure??, is the fuel pump working?/ if you have fuel and pressure then you have to check signal at the injectors, so if you have fuel pressure and a good injector pulse the next step is to check the injectors, this may require removal, good luck
SOURCE: firing order ford 300 six and #1 position on distributer cap 1990
THE 300 4.9 ENGINE FIRING ORDER IS 1 5 3 6 2 4 THE NUMBER 1 POSITION ON DISTRIBUTOR CAP IS AT 6 OCLOCK POSITION.
113 views
Usually answered in minutes!
×