The power windows do not work at all. The driver side lock button doesnt work. Master switch, relay, n wiring have been replaced and checked. Door seems to be getting no power. Is it the front ecu? The passenger side lock button works but doesnt unlock driver side and no window buttons work.
Check inside of door where wiring comes thru for broken wires ,ECU doesn't control windows or door locks. You didn't state what model vehicle you own. But opening and closing door on drivers side causes broken wires on numerous vehicles over the years, most makes and models. Split boot and check all wires inside for breakage.
SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
SOURCE: Power windows, door locks and mirrors inop.
Sounds familiar - I pulled the rubber boot back and found the black wire was broken. I stripped the wires and put on a couple bullet connectors (terminators) and all is good. Just wish I would have seen this post before I took the door panel off... Oh well...
SOURCE: 2005 Chrysler Pacifica passenger doors have no power
If your alarm went off, it could be that someone had tried to break into your car. They most likely may have cut some of the wires inside your door with what ever device they may have been using. Look for evidence between the bottom of the windows and doors where the problem is. If not, then it is possible that your automatic window assemblies are malfunctioning. Do you hear the motors run on the windows when you go up or down with the switch? I also have a Pacifica, 2005, however no window problems yet.
Good Luck,
Ray
SOURCE: Camry 1996 automatic power lock doen't work, but windows work.
if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks
SOURCE: On my 2003 Saturn Ion, Driver Side window controls not working
Did you ever solve this problem with your windows? My 03 Ion 2 is doing the same thing. We think it's a wiring issue. Any suggestions? Thanks, Kristen N!
368 views
Usually answered in minutes!
×