How do I reset auto back windows after battery change?

have to check manual for reset codes for radio should fix

(a) Turn the engine switch on (IG).

(b) Halfway open the power window by pressing the power window switch.

(c) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 1 second after the power window is fully closed.

(d) Check that the AUTO UP/DOWN function operates normally.

If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time. If not normal, follow the steps below.

(1) Disconnect the negative battery terminal for 10 seconds.

(2) Connect the battery terminal.

(3) Turn the engine switch on (IG).

(4) Halfway open the power window by pressing the power window switch.

(5) If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time.

If not normal, follow the steps below.

(6) Turn the engine switch on (IG).

(7) Halfway open the power window by pressing the power window switch.

(8) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 12 seconds after the power window is fully closed.

(9) Check that the AUTO UP/DOWN function operates normally.

If on a GM car the battery has been disconnect the windows may need to be reprogrammed
The following steps explain how to program the side door window regulator motors:

1. Press and hold the power window switch until the window is fully DOWN. Continue holding the power window switch for approximately 3 seconds.


2. Press and hold the power window switch until the window is fully UP. Continue holding the power window switch for approximately 3 seconds.


3. The power window regulator motor is now programmed for the express function.


4. Repeat this process for all of the power windows.

first take main battery cable out for one houre and return it back if there fine so its oke if not do below steps plz
set in car and close or glasses 1st- open ur window full auto and close it auto 2st-open passenger full auto down and full auto up 3st-open ur back window full auto down and then full auto up 4st-open rear window of passenger full auto down and full auto up
hope this will work if not tray same steps twice it will reprogrm
let me know plz if still

to reset any window open it half way down then
let it fully close and hold the button up for about 10 seconds. do this mithod to all auto windows encloding the sunroof . afterall try them from the driver side

try going to passenger door window switch and reset it by going down and holding for extra 3to5 seconds after window is down, do same to go up, then try doing it with master switch don forget to hold it longer, this is a reset also used on Scion vehicles, hope it helps.
Good luck

Dear Madam or Sir,

you re-initialise the system by moving the window upwards and hold the button for four seconds. Then move down the window and hold the button for another four seconds. Turn ignition off , wait two seconds. Now the auto function should be operable.

CHECK FUSES .

take the positive side off the battery for about 3 seconds and then put it back on and it should reset the code

You have to press and hold the window button till it's unwound all the way down then hold it for a further 2 seconds, do the same with it on the up setting - this will reset the auto switch. Worked on my Accord after I changed the battery.

regards
Richard