SOURCE: need firing order for a 1998 chevy malibu 3100 v6
The Firing order is 1-2-3-4-5-6. But the wires go on the coils in this order1-4-6-3-2-5
SOURCE: How do I install driver side inner tie rod on my
you don't need to remove the whole rack but do need a special tool called inner tie rod tool. can be bought or borrowed form most auto parts stores. first remove wheel. next loosen the jam nut on inner tie rod at the end of outer tie rod. remove cotter pin and nut on outer. use seperator or pickle fork to seperate outer from knuckle. then remove the clamps on boot and remove. then take tie rod tool and find the right size end and turn with 1/2" ratchet or breaker bar. it will turn hard at first cause of it being staked on to the threads. when it is off install new part with loc-tite on threads and tighten. when tight crimp inner flanges with either plier or hammer and punch to the rack. install in reverse order. remember to measure distance from clamp on outer side of boot to jam nut so you can get the alignment close until you get to shop for alignment.
SOURCE: Repalcement process on inner tie rods 05 silverado
undo bolts on inner and outer tie rods,u might need balljoint fork separator or 2 jaw puller to take them off of relay rod and steering knuckle,measure lenght of tie rod,loosen tube clamp and undo tie rod from tube,when installing make sure lenght is the same as before or wheel alignment will be off!
SOURCE: how difficult to replace inner tie rod end on 06 silverado 2wd?
Not that hard, just spray the tie rod sleeve with WD40 night before and let it soak in. Remove the collier pin and and nut and hammer the old inner tie rod end out of the Track rod with a 5 pound sledge hammer. Remove the inner tie rod end from the sleeve and don't forget to mark the distance so you can place the new tie rod end at the same length. Reinstall the inner tie rod end to the Track rod and tighten the nut and replace the collier pin with a new one. Grease the fitting and go for a test drive, if the truck does not wonder then your good to go with out a alignment. Good luck and hope this helps, Note, make sure you have to right inner tie rod ends. Each side has different thread rotations.
SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs
A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.
45 views
Usually answered in minutes!
×