Remove cluch fan witch way do you turn the nut

Temperature not getting hot enough in the engine(bad thermostat), bad engine coolant sensor. Codes help.

To remove clutch fan: 1. Remove the fan shroud. Remove the top screws & the two side screws with a socket & ratchet. 2. Remove the top radiator hose by using a screwdriver to loosen the clamps. 3. Hook the ends of the water pump pulley lock on the bolts on the outside of the water pump pulley. 4. Remove the large nut on the fan with the 1-1/16 wrench by turning counter clockwise. 5. Replace the fan by holding the nut perfectly level with the water pump post & start the nut by hand. --------------------------------------------------------------------------------------
FGtech V53

counter clockwise

they make a special tool to remove the fan clutch.i just use a air hammer to remove it.remove it counter clockwise.

On some fans their is a large nut to remove it, right by the fan. Some of these are lefthand threads.

the radiator fan is mounted to the clutch, in other words remove the bolts / nuts that is holding the fan assembly to the water pump usually just four nuts once you pull the fan assembly the part that yo seperated from the water pump is the clutch, now remove the fan blades and mount thm on the new clutch assembly the piece which mounts tt the water ump is the fan clutch

clutch and fan assembly are connected to the pump with four bolts. Have someone push down on the drivebelt so the pump pulley won't turn and break each bolt free, then remove the bolts.

you need to go get a fan clutch wrench at local parts store the big looking nut on the fan clutch has to com off firts befor you remove belt it turns counter clock wise

there are 4 nuts on the back of the fan and a big nut on the fan shaft turn the one on the shaft toward the right

I push on the belt that goes around that pulley, to tighten it up & help hold it in place while I undo nuts/bolts.