How do i reset the engine control module in my 1995 jaguar vanden plas 4.0 will this reset ALL setings because i think this car needs it had 3 owners and cant seem to get memory and othe little things.

check the inertia/fuel shut off switch located lower A post drivers side on uk cars may be other side for us spec press it down on top to reset it if ok the crankshaft position sensor is next to check common problem

The reset button is behind the carpet, just above the drivers foot pedals (right hand side on a right hand drive). It's function is described in the owners manual, which may be located in a slide at the top of the glove box.

use a scanner connected to the data link connector.

check for a bad fuel filter or a leaking rubber line after the fuel pump . To dump that much fuel so quickly ,the fuel pump is pumping to a broken /split hose or steel line.

Forget about fuse box id. Just test all fuses one by one with a test light until you find the bad one.

The EVAP system purges any build up of vapours from the fuel tank and burns them thro the engine at pre-detemined times. This is done by means of the EVAp solenoid which when energised allows engine vacuum at one side to **** the vapours from the other side and pass them thro engine. Look for the black solenoid with two vacuum pipes and two wire plug on it. think you may be correct and have disturbed it when doing the air filter.

if you can help yourself there are 97 ads for "1995 jaguar manual" on eBay as of 4-27-11.

Check engine light. takes a scanner to read the codes

its on the right side of luggage compartment.

i know the dealer is obvious, but you can also check with bentley publishers in Cambridge, Mass