2011chevroltet malibu transmission codes uo100/po700/p182e

co561 System Voltage unstable,, po751 Shift solenoid A CKT
performance or stuck Off,, po700 Trans Control Sys. Malfunction
these are OBD codes, hope that helps....

It means there is at least one transmission code set in the TCM's memory. P0700 is an informational code only. More diagnosis is necessary to identify what the transmission fault is. This requires a scan tool that will communicate with the transmission module
http://www.obd-codes.com/p0700

po700 is just telling you to check the transmission control module for transmission codes. May need a dealer or high tech reader for this.

code po700 refers to transmission control system/mil -malfunction==causes ==wiring---TCM
code po701 refers to transmission control system -range/performance problem===causes wiring --tcm
As both show the TCM as a common point of the fault I would replace it.

Code 731 is for a problem with the gear ratio for first gear.
Code 700 is a general fault code that means you have a problem with the transmission control module or the transmission.
The 731 code can cause the 700 code, and the problem could be a speed sensor inside the transmission. The computer does not like the signal being sent from the transmission to the computer.

Well looks like I have answered this question before for someone else.
Code 700 is for a problem with the transmission control module, 731 is incorrect first gear ratio, 841 is a problem with the low-reverse pressure switch, and 1776 is a problem with the low-reverse solenoid.
These components would need to be tested by a transmission shop.

2000 caravan with codes p1782 and po700,this is transmission codes, i will tell you this, with out a good scan tool to check the problem correctly you will be just throwing money at it.

this may be due to a bad shift solenoid pack or wiring or internal transmission problems. sorry to say but these transmission are junk.
I would have a transmission shop or dealer check it, maybe the dealer unless you know a good transmission shop that will not try to sell you a rebuilt ******.

that would be your transmission control module. it is located on the front of the transmission. here is a picture and my link to my garage if you need more https://www.facebook.com/TedsRepairs help

po700 Transmission Control Module Requested Malfunction Indicator Lamp Illumination, p1779Engine Torque Delivered To Transmission Control Module, Signal p1780 Engine Torque Reduction Signal Circuit p1795 Controller Area Network Bus Throttle Body Position

PO 700 -- all I have without service manuals for
your exact truck is a generic

Transmission Control System Malfunction

Having once owned a trans shop

My advice--stop using it until resolved