Question about 1998 Mitsubishi Montero Sport

Open Question

Truck will not go into first gear and pull off when you shift it to drive. it acts like it is trying to start in drive or high gear.

It will do ok if you shift it to fisrt gear and manually shift to 2, 3 , & drive. it will not downshift when you slow down. I notice that it is shifting real hard from park to drive or first gear. its acts like the torgue convertor is not sliping or something. the shift cable at the intake is reall loose also, could this need adjusting? it also seems to have to much fluid in the tranny?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 23 Answers

SOURCE: transmission vibrations to heavy shaking between 30-45 mph

tranmission mount is broke change it before it breaks your motor mounts.

Posted on Jan 10, 2009

Ad
  • 7 Answers

SOURCE: automatic transmission Shift problem

you should first check gear box oil ,level and clean filter.lee

Posted on Jan 31, 2009

  • 26 Answers

SOURCE: Transmission does not shift on "D" - '00 Montero Sport

i would check out the timing. but i little trick the i have learned was to put break fluid in your trany. it cleans out all junk inside

Posted on Aug 05, 2009

  • 143 Answers

SOURCE: 93 Mitsubishi 3000gt overdrive problem

I think rebuild try and service it if you find any lining material in the pan bad news

Posted on Jun 06, 2010

  • 32 Answers

SOURCE: I have a 1998 mitsubishi

sounds like an engine mount is broken mate.front or back mount would do this.

Posted on Dec 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chrysler Sebring occasionally wont shift gears or acts like its in neutral


run fault codes and check for TCM problem . Change the fluid and clean the filter. Have a pressure test done on the box to check for internal mechanical problems. While the pan is off have the bands and clutch pack adjustment checked.

Feb 09, 2014 | Chrysler Sebring Cars & Trucks

1 Answer

Was driving a 93 chevy truck 1500 350 was pulling fine shifting fine then this morning went out cranked the truck and nothing no pull in any gears fluid levels fine no smell reved moter acted like it it...


time for a trans rebuild.
Best bet is to get it to a shop as it just may be something easy, but as a chevy mechanic, I honestly HATE every GM transmission.

Jan 29, 2013 | Cars & Trucks

1 Answer

Transmission won't shift into high gear.


are there any codes? Does it shift ok in 1st and 2nd? sounds like your over drive shift solenoid or your 3 and 4 shift solenoid is stuck and needs to be replaced

Jan 02, 2013 | 1997 Chevrolet Blazer

1 Answer

My transmission in my 97 ford f150 wont move unless i put it in 4 low and now wont switch out of 4 low


Its Possible the chain in transfer case is stretched I had the same problem a used case was 250 at my local salvage yard

Nov 23, 2012 | Cars & Trucks

1 Answer

1993 chevy k1500 transmission problem


Do you mean start the car in drive? if so that problem is inhibitor switch. Other shift problems can be caused by TPS (throttle posistion sensor) if applicable

Oct 05, 2012 | 1993 Chevrolet K1500

1 Answer

Dodge dakota 2005 automatic transmission, when starting from a stop or low speed sounds as if it is low on fluid rpms high started doing this on tollway when pulling out from the toll both ????seems to...


Manually shift thru all gears up & down the scale. Try adding Motorcraft Additive Friction Modifier, available from Ford parts dept. This REALLY STINKS!!! Don't get any on you. Pour into trans fluid. Drive a few miles shifting manually thruthe gears, then do a normal start stop drive several times. This will luburcate trans, normally used for differential but has worked in automatic transmissions of all makes for years. Otherwise mechanical problem for transmission repair facility.

Nov 07, 2010 | 2005 Dodge Dakota

1 Answer

Can acts like it is going to stop running when you


try checking all air intake hoses from air cleanr to inlet manifold for splits or tears and if they are ok have your air flow meter checked

Apr 04, 2010 | 2002 Jaguar X-Type

1 Answer

My 1997 GMC Savana with a4L60E won't down shift unless i do it manualy. when i start it and put it in drive it acts like it is in high gear.


Hello,
Is your check engine light on?
It sounds like you have a failed shift solenoid on the valve body.

I hope this helps.

Roy

Nov 04, 2009 | 1997 GMC Savana

2 Answers

2000 GMC Jimmy SLT 4wd, 65k miles, baby'd, driven


bad transmission, it will need rebuilding or replacement. sorry....hopefully this helps

Aug 16, 2009 | GMC Jimmy Cars & Trucks

Not finding what you are looking for?
1998 Mitsubishi Montero Sport Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...