Timing chin nissan qg16 replcement - 2005 Nissan Armada

The torque settings for a Nissan Almera QG16 engine can vary depending on the specific component or fastener you are referring to. However, I can provide you with some general torque specifications for common components in the engine. Please note that it's always recommended to consult the manufacturer's manual or a qualified mechanic for accurate and up-to-date torque specifications. Here are some approximate torque values for certain components:

1. Cylinder head bolts: 25-30 Nm (18-22 lb-ft) initial torque, followed by an additional 90-degree clockwise turn (angle tightening).
2. Main bearing cap bolts: 25-30 Nm (18-22 lb-ft).
3. Connecting rod bolts: 15-20 Nm (11-15 lb-ft).
4. Crankshaft pulley bolt: 140-160 Nm (103-118 lb-ft).
5. Camshaft sprocket bolt: 85-105 Nm (63-77 lb-ft).
6. Intake manifold bolts: 15-20 Nm (11-15 lb-ft).
7. Exhaust manifold nuts/bolts: 25-30 Nm (18-22 lb-ft).
8. Spark plugs: 15-20 Nm (11-15 lb-ft).

Please check diagram. I hope this helps.

This link is for a manual that has a lot of engine specs. It may have what you are looking for.

http://www.championbrands.com/aera-torquespecs.pdf

was the proper coolant installed? Poss wrong rad or thermostat?

it is only a nm figure for the initial setting of the bolts
after that it is an angle measurement and not a torque setting
get a workshop manual and the correct procedure and settings are there

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Check this link for the information.

http://www.championbrands.com/aera-torquespecs.pdf

Nissan 1 6L Timing Chain Rattle part 1

Nissan 1 6L Timing Chain Rattle part 2


SR20DE replaced timing chain

http://www.nissan.com.sg/recall/recall.cfm
Have a read