Question about 2000 Chevrolet Tahoe
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
When bleeding brakes after the system has been opened for service (you didn't say if you were doing any work on the master cylinder) you should start with the farthest wheel away from the master cylinder, which is the righ rear. Fill the master cylinder, then have an assitant "pump up" the brake pedal. Tell them to hold it down firmly, then open the bleeder on the wheel cylinder(s). Do not release the brake pedal until you have closed the bleeder valve again. You'll know when the air is out - there won't be any more bubbles. Since this vehicle is 2001, this would be a great opportunity to flush the system. Just make sure you have enough brake fluid (DOT 3 or 4, depending on your vehicle). Good luck!
Posted on Mar 15, 2009
Why were the brake lines replaced?
Sounds like the mastercylinder may have run dry. You have to bench bleed the master and then DO NOT allow fluid to run low, while bleeding brakes...
if master cylinder runs low on fluid and air gets in, almost impossible to bleed with out releasing the lines and bleed master it self.
Posted on Sep 20, 2009
you are probably correct. there are two contacts on the level sensor that wear out, which gives you the fluctuating gauge.
Posted on Feb 24, 2010
Tips for a great answer:
Feb 01, 2015 | Cars & Trucks
Sep 10, 2012 | 1987 Honda Accord
May 11, 2011 | 2000 Chevrolet Silverado 1500
Mar 27, 2011 | 2002 Chevrolet Tahoe
Nov 01, 2010 | 2000 Chevrolet Tahoe
Feb 24, 2010 | 2000 Chevrolet Tahoe
Jan 23, 2010 | 2000 Chevrolet Tahoe
May 23, 2009 | 2000 Chevrolet Tahoe
Apr 18, 2009 | 1999 Chevrolet Tahoe
280 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: