SOURCE: location of the Heat resistor in a 2003 Chevy Malibu?
Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.
SOURCE: Timing Chain Cover, Chain, Sprockets, replacement
2.2L VIN 4
To Remove:
To Install:
SOURCE: where is the crank sensor located on a chevy
the 3.1 engines crank shaft sensor is located behind crank shaft pulley.the 2.4 engine crank sensor is next to oil filter.
SOURCE: oil filter location 2004 Chevrolet Malibu Classic
Standing at the front of the car looking at the intake manifold, its on the right hand side of the manifold about 6 inches down from the valve cover under a black cap with a 32mm top on it.
156 views
Usually answered in minutes!
×