Program car remocon 1996 camry

You'll need to contact the dealer on this.

It could be many reason for remote is not working ,check the battery with replacing it with fresh new one , check the antenna for remote receiver and then check the connectors to remote receiver control unit under driver sit for loos connection ,if all seems ok you might replace unit

follow this link for a step byu step guide
Camry programming instructions for TDS Rostra keyless entry remote FCC...

Great news, your 1998 Toyota Camry Key Fob is self programmable. Below are the programming instructions. Be patient, it might take you a few times to get this right. It is all about timing.

Most remotes can be self-programmed. If this procedure does not work, you must have your remote programmed by a professional automotive locksmith or dealership.


Obtain all remote transmitters for this vehicle.
1. Insert key into ignition and turn ignition switch to ON position.

2. Locate the ECU (Engine Control Unit) and press and hold the ECU PROGRAMMING button for 3 seconds. The ECU will be located under one of the front two seats, the trunk, or under the dashboard on the drivers side. You will need a small pointy object like a pen to depress the ECU button. After pressing the ECU button for three seconds, you will see the STATUS MONITOR LED turn on for 5 seconds. Vehicle is now in programming mode.

3. Press and release the top button on the remote. The STATUS MONITOR LED will turn off. A chirp will be heard as well as one flash of the exterior lights.

4. Turn off the ignition. Programming is now complete, test remotes for proper programming.

acura has to reset the system if it is factory

"Connect pin 1 of the 16-way data link connector to chassis ground or to pin 4 of the 16-way data link connector."

What does this mean??????

Click on the following direct, free Link. It has several Timing Belt + Mark Diagrams for your 1996 Toyota Camry. It shows Diagrams for both the 2.2L and the 3.0L Is also has additional - very helpful Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1996/make/toyota/model/camry/1996_toyota_camry_timing_belt_diagram_marks.htm

This website lists key and remote programming instructions for a range of vehicles and it's free.

www.carkeyhelp.co.uk

go to your owners manual it should tell you just how to do it.

sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!