SOURCE: where are the fuses in
THE MAIN FUSE BOX IS LOCATED UNDER A COVER WHICH IS IN THE CENTER CONSOLE (BY YOUR FEET IF YOU ARE SITTING IN FRONT). THERE IS ANOTHER FUSE BOX THAT IS LOCATED UNDER THE HOOD (RIGHT NEXT TO YOUR BATTERY).
SOURCE: saturn shifter linkage
The bushings on ebay work from what I understand, but a bit pricey. The bushing in question is a P.O.S. for sure. Easy fix though if you have tools and time. First I drilled out the ball that the end of the linkage,the one your faithfull broken bushing use to ride on. popped a 3/8 inch bolt thru the drilled hole, put a piece of 3/8 inch heater hose "cut to length desired" over the bolt ( this is what the linkage ring rides on ) put a rubber gromet or rubber washer that has a hole big enough to fit over the heater hose on each side of the linkage ring ( oh and dont forget the lube - regular grease will eat rubber so use good judgement). put a washer big enough to keep your gromet or rubber washer from falling off, and then a lock nut, and I cannot stress the fact that it has to be a lock nut. DO NOT tighten the living **** out of everything, that little linkage ring is plastic after all just tighten it "lightly snugish" and just make sure your lock nut can't be un-tightened by hand. I hope all of this makes sense, anyway total repair cost- one hour of my time, about $4 of parts at the local auto parts store. best of all, it should outlast the car. Oh fyi, I used rubber parts because that is less likely to break the plastic linkage ring. Showed what I did to a mechanic in town, said now he actually knows what to do next time one of those f-ing saturns comes in with busted linkage. Good luck fellow "manual" saturn owners!
SOURCE: My 2001 SC1 Saturn heater is not working. Had the
It is probably a vacuum-controlled device; look for vacuum leaks under the hood or a ruptured vacuum reserve canister; the connectors are often fragile and break off.
SOURCE: muffler strap broken on 2001 saturn sc1 series how
Part is a dealer only part. There is 2 pieces to it. The strap is all you should purchase. The other part disconnects via a treaded bolt through the rubber mount above the muffler. Loosen the bolt/clamp on the muffler first this will give you the room to reach above the muffler with good lighting.
SOURCE: how to bleed the clutch on a 2001 saturn sc1
very hard to get to, shops sell them as pre-bled master and slave unit.
117 views
Usually answered in minutes!
×