Where is the airbags module
SOURCE: Airbags deployed
You have to disconnect the battery, replace the air bag modules (air bag modules are the things that explode in your face) and the crash sensors and the control unit or module that came with it. Reconnect the battery and the car should start. Hope this is helpful.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: 2007 chevrolet tahoe airbag problem
air bags can be tricky and dangerous. after all they are a controled explosion. static fom your person could set it off. therefore i highly recomend you take it to the shop
Testimonial: "v.good "
SOURCE: the airbag light stays on my 2002 chevy tahoe. can
no it cant .use a glow plug relay to work the airbag light ,so it will pass the annual vehicle mechanical inspection but dont pass this trade secret on .If vehicle taken for test and airbag light seen then its a failure ,Only when its had a new computer and airbags fitted with a certificate from the dealer only will the vehicle pass ,normal cost????2000euros
SOURCE: airbag light stay on 2003 chevy tahoe
The air bag light will remain illuminated if a fault has been detected in the air bag system.
The onboard computer will need to be interfaced with diagnostic equipment to read the fault.
This is also the only way to reset the light.
Good luck, I hope this helped.
1,565 views
Usually answered in minutes!
×