Vehicle loses power when the throttle is full depressed, on an incline it loses total power......it will work while the throttle is lightly depressed?
SOURCE: check engine light code came up p2101 throttle
There is either a high or low circuit problem with the motor. The ecm, or called the computor, moniters the cuircuit for the motor.
The best thing to do is have the control motor checked and the ecm. One of them is bad.
Testimonial: "fast help great job thanks "
SOURCE: p0014 engine code
THE CAM SHAFT ACTUATOR IS LOCATED IN THE CYLINDER HEAD ON THE FRONT RIGHT HAND SIDE JUST ABOVE THE POWER STEERING PUMP. AFTER YOU REMOVE THE ACTUATOR CHECK TO SEE IF ANY OF THE SCREENS ARE DAMAGED OR MISSING. IF SO REPLACE THE ACTUATOR. ALSO CHECK THE CRANKSHAFT END PLAY. IT SHOULD BE BETWEEN 0.0044" - 0.0153". if excessive crankshaft end play is causing this concern, it will be obviously out of specification by as much as.050" or more when a pry bar is used to move the crankshaft back and forth. IF THIS IS THE CASE AN ENGINE REPLACEMENT IS RECOMMENDED DUE TO THE AMOUNT OF DEBRIS IN THE ENGINE. IF NO EXCESSIVE CRANKSHAFT MOVEMENT NOTICED REPLACE THE CAM ACTUATOR. IT WILL ALSO BE NECESSARY TO DO AN OIL CHANGE.
SOURCE: Replace Fuel Filter on 2006 Chevy Aveo Hatchback
If the fuel filter is mounted inside the fuel tank at the pump it does not need replacing and is a permanent filter. All you have to do it follow the fuel lines from the fuel tank to the engine. If the filter is mounted in the fuel line you will find it.
SOURCE: 2006 chevy aveo abs break light comes on. breaks
Put a scanner on the vehicle and get the code .
Obviously its an ABS PROBLEM and not the hydralic portion of the system.
Either a wheel sensor or the module were my experiences with your problem.
Once you get the code do the repair necessary ( use a shop manual this is not a difficult procedure to do)
Good luck
SOURCE: how do you change an oxygen sensor on 2006 chevy aveo
There is a special socket for O2 sensors which allow the wires to stick out and not get twisted up. It's not expensive and available at most auto parts stores. Disconnect the sensor from the wiring harness, with the plug and then use the socket to remove and replace the new sensor. Re-connect electrical plug.
Please rate this answer. Thank you.
1,604 views
Usually answered in minutes!
×