WHY IS THERE NO FUEL GETTING TO THE INJECTORS AFTER REPLACING THE FUEL PUMP AND THE FUEL PUMP RELAY?
SOURCE: 1996 Crown Vic, Valve noise under heavy acceleration
No use what's in there, but have the engine de-carboned by a Ford dealer, or remove the octane adjust shorting bar located near the ignition module (retards timing 2 degrees), this will in most cases cure the issue unless there is allot of carbon in the cylinders. There are also methods of ing this de-carbon procedure at home, check on the internet for tips.
PLEASE RATE THIS SOLUTION
SOURCE: Wiper motor replacement for a 99 crown vic
I replaced the same part on a 1994 Crown Vic. There are a few bolts which go through rubber mounts on the firewall and that is how the wiper motor fits against the firewall. There is a clip on the wiper drive that must be pressed and slid off the wiper shaft. The hardest part was getting clearence between the engine and wiper motor. If I remember there was a way to turn the wiper case to clear the engine. I have asked myself why this was engineered like this? There is nothing important in the way that 3/4" of clearance could have been given for removal.
SOURCE: can i replace a fuel pump on a 1998 crown vic
no, if you think it is too difficult it isnt, just get a manual from the library or an autoparts store , and seriouslt make sure the tanks is low or empty and keep clear from sparks !!!
Testimonial: "thank you"
SOURCE: Location of fuel pump relay on a 2001 Ford Crown Vic
where is the fuel pump relay on a 2001 crown vic p71
SOURCE: where is fuelpump on 2003 crown vic police intercepter
can you replace a fuel pump from a 2000 Crown Victoria with out removing the gas tank
486 views
Usually answered in minutes!
×