My 2000 jimmy gives me a problem starting up and then when it does run it stalls while in motion
It could be the Throttle Position Sensor ( TPS ) or Idle air control motor. Determining this will help be a guide. If it idles but you cannot accelerate, then it could be the Idle air control ( IAC) or the MAF ( mass air control sensor).
If it idles but stalls when you try to accelerate, then I would first suspect the TPS. You could throw a lot of money at this problem and not solve it. I would suggest getting the computer scanned to find out what codes it is throwing before buying any parts to swap.
Hope this helps!!
SOURCE: where is my 1 2 shift sensor 2000 gmc jimmy
Inside trans. pan at the rear of the valve body. They have a wire clip which holds them in.
SOURCE: 1994 GMC Jimmy hard to start and runs rough when first started
i think if you checked the sparking plugs and map sensors then check your distributer its maybe not delivering the current nedded to perform the spark to some of the cylinders
SOURCE: 2000 GMC Jimmy won't start
i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ
SOURCE: How do you change a 2000 gmc jimmy blower motor?
How do you know the motor is bad ? Have you run 12 volts to it directly ?
We have the parts for you, and step by step instructions :
www.aescompaniesllc.com
Please click on contact us.
156 views
Usually answered in minutes!
×