The low pressure switch would be around the air dyer system.
If line drier is cool on one side and warm on other you have a line restriction. Is compressor cycling on and off.?.. be careful jumping low pressure switch...The high pressure on low side is restriction going to evaporator coil in firewall... check for a filter in cab for evaporator coil it may be stopped up
SOURCE: 2006 dodge ram 2500 4x4 diesel replace brake pads front and back
Straight forward job. Remove wheels, remove 2 caliper bolts per wheel, check bolts,and bushings for wear/corrosion and lubricate, remove calipers, remove brake pads, push caliper pistons into calipers, replace anti-rattle clips, put new pads in, put caliper and bolts in, put wheels on. Start truck and press brake pedal several times to take up slack and you're done.
SOURCE: I have a 2006 Dodge ram 2500 diesel I can not get
First I thought it was the fuse panel or the power module but with our newer truck the computer told the power module not to send power to my A/C compressor b/c the A/C Clutch was out, (you can't replace just the clutch so I just had to replace the compressor and not the power module b/c the truck's computer told it not to send power this is the same with anything that goes wrong with the truck the computer tells it not to send the correct power to the part that is broken thus it seeming like the part isn't getting power, The power Module (fuse panel) is just doing its job replace whatever went out first or is bad, and the power will naturally be restored or you can go to your dealer and have the Power Module Flashed as they call it which resets it.
Jason
SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
SOURCE: What should the high and low side freon pressure
The re-fill kit for the r-134 will only fit on one of the sides. You want to fill the low pressure side, but be sure you have a gauge not to overfill. he high pressure will be the larger side. But the gauge will only fit on one of the inlets for safety precautions.
367 views
Usually answered in minutes!
×