I had a brake hose break and after it was repaired the abs and traction control light on dash stays on.is there any way i can reset them, or is there still an issue with the brakes,thank you.
I wonder if someone forgot to reconnect the connector from the sensor?
SOURCE: Traction Warning Light & ABS light on.
one of your wheel sensors are bad. if you go to napa they will let you use a code reader for free and that will tell you which wheel it is and you can replace that sensor. they are kinda expensive @ around 100 bucks a piece.
SOURCE: 2001 S Type Jaguar ABS and Traction Control fault lights on
Hi First I suggest that you get a diagonostic check on ABS system. and then a visual inspection of the brakes. Warped brake rotors do not make noice, but the steering will start to judder when brakes applied at around speeds from 40 up . Possible cause that the vehile picked up something from road such as nylon/ plastic/stone Mike
SOURCE: ABS light on fronm start up. Had problems witht he
just a guess on this but but have you tried resetting the computer for the switch?
SOURCE: 2001 jaguar s type. Traction controll fault light
your traction control mechanism uses the abs breaks to slow the spinning and give you better traction. i'm thinking your traction control sensor has gone bad
SOURCE: s type jag 2003 abs warning light on dash board is
Check your brake fluid level first. If it is fine then you probably have a bad abs brake sensor.
695 views
Usually answered in minutes!
×