How do I change the fuel injector filter
SOURCE: FIND FUEL FILTER
all you have to do is take off the gas cap to help release the pressure and take the clips off on each side of the fuel filter and make sure you put the filter back on and the arrow in going toward the front of the car.
SOURCE: Engine bogging down after changing fuel filter and injectors
possible EGR valve it could be clogged catalytic converter
SOURCE: how do we take chrome bar over fuel injections off
for the most part there is two 10-mm bolts one in the front and one in the back remove them and lift up give these website a try www.alldatadiy.com and www.autozone.com wish you the best Michigan Man
SOURCE: I need a wire diagram for 1998 blazer fuel
Haynes Manual 24071 includes wire diagrams for all components. On the injector you have a pink and dark blue wire both are hot and signal wires. The only ground in the system is on the fuel pump and sender unit. Diagram 12-26 in the haynes maual.
SOURCE: 1985 s10 will not start.
Odd one,sure the fuse labeled inj is ok? Also pull the dist. cap check for side to side play at the rotor shaft,if the bushing is worn out the pickup coil won't work right.While you're there,crank it and make sure the rotor is turning(ie timing chain of shaft gear failure)
30 views
Usually answered in minutes!
×