No power to back window switch

If it's the only window that isn't working it has nothing to do with the fuses. You do not have a separate fuse for each window. If the power window fuse was removed and not placed back into the correct slot, all of your windows would not work. I would start at the window switch and see if you have power to the switch, then move on down the circuit to find the issue. If you end up with the motor getting power when you activate the switch, but nothing happens replace the motor.

I suggest trying the following: put window down using switch on driver's door. Then hold passenger switch in the down position for 5 seconds. Then put window up using switch on driver's door. Then hold passenger switch in the up position for 5 seconds. Then turn off car and pull key. Put key back in and turn on power. Then test rear window switches to see if they reset.

It may be that the rear power window regulators/ switches have gone out for each door and need to be replaced. Also, check to make sure that power is being received at each switch. If no power, they can be tested by getting power independently to each one. If you are not a handy DIYer, getting them checked out by an experienced mechanic may be the best way to go.

pull out the set of 4 switches and switch the wires from that window to a different switch to raise it then put the wires back in place and put switch panel back

Possible bad window switch. If the window motor were bad, or if power was not getting to the switch, the window wouldn't work at all. The switch should be tested for correct operation. Remove the switch and apply 12 volts to the power terminal of the switch. Then toggle the switch and use a 12 volt test light to confirm continuity on the up and down terminals. If it is defective, replace it with a new switch.

How To Diagnose your Power Window Problem Is the Switch or motor bad

wiggle the switch that u use to put the window up an down....it sounds like a bad conntact in the window switch...if it starts to go up replace the switch

well if will it roll up with any of the swithches driver main switch and or switch on that door if neither switch will put up that window then you going to need to replace your power window motor in the back door. always check your fuses and relays first thought

if it helps please give me thumbs up

check to see if power is coming out off switch to back window. if not switch is bad. try this if need be to find out if wire is broke. run a wire to back window from output on switch, touch or put it on defroster lug at back window. if it works then the main wire is bad, make sure all fuses and relays are ok. heres an eaiser way !! remove switch, jump from positive wire to wire going to back window. thats if wire is ok, to back window.

Pinched wire between door jam and switch console

hi, there is a relay for the windows. in the fusebox (s) there should be a relay for each window. these relays do fail (open circuit on switch side). the feed POWER side may be shorted. these circuits are hard to find the fault, but check all the door relays. the motor can stick and put heavy current to blow the fuse, if you leave the engine OFF and put the ignition ON press the other window and listen for this relay noise. a click can be heard to pinpoint the location of other relays. once you find these switch relays to determin if these are working and use this to put the rear window back up. gerry