Attached to the frame just to the right of your rear tire on passenger side. just to the left of rear tire on driver side. there are two of them that look like a little hinge. best of luck.
jeff
SOURCE: 2004 hummer h2 leaks water from roof over front
Seal all the lights on top. Mine flooded from the water running down the light harness wires. Used clear rtv sealant and fixed it. You will have to remove the seal the two larger lights on the corners.
SOURCE: hummer h2 idle rpm too low
I can't solve the problem but was hoping you found the answer. I have a 2003 Hummer H2 and I am having the same problems if started in park or Neutral it will idle fine but if I put it in drive or reverse it will not idle
Did you find the solution and if so could you email me the fix.
[email protected]
Thanks,
Troy
SOURCE: change light on 2006 hummer h2
it can be easily changed by removing the plastic cover then u will see the light bulb, don't try to change it from the back, it wont open :)
SOURCE: top speed of h2 hummer
it's a heavy car, so the H2 does 0-60 in 8.2 seconds.
and Max speed is 100 Mph
SOURCE: I need to remove the luggage racks from my 2007 Hummer h2 SUT
I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.
?€¢
The IPC detects a loss of class 2 communications with the PCM.
When the fuel level is less than a pre-determined value, the low fuel indicator illuminates.
Reviewing the fuel system description will further explain how the system functions. Refer to Fuel System Description .
Do you know about class 2 serial data communication .
Do
130 views
Usually answered in minutes!
×