2011 Kia sorrento lug nut torque - 2002 Nissan Sentra

Hey Shirley,
here is the sensor:
https://www.rockauto.com/en/catalog/kia,2011,sorento,2.4l+l4,1446078,ignition,camshaft+position+sensor,7192
This is generic,, but will get you started..
https://www.youtube.com/watch?v=hJjA4W0s7YA

134/181

2012 KAI.2.2 ..16V KEEP GOING IN TO LIMP MODE PLAESE HELP

728*18.

torque is about 90ftlbs torque.

If you can find just the studs and not have to buy the whole hub assembly, screw a lug nut on flush to the stud and drive it out with a hammer, make sure its in a position to have room on the back side. Put in new stud and with a few spacers tighten a lug nut to seat it.

Most likely you will have to have it pounded out and replaced with a new wheel stud. These are vehicle specific and are sold at auto parts stores. If you can take a lug nut with you.

Lug studs are pressed in from the back side and on most cars, if you rotate the axle to a specific point there is enough room to knock it out. then once you have the proper replacement, it can be "pulled" back in using a lug nut and washers as spacers. I have had lug nuts get ruined by this procedure so buy extras.

Lower ball joints. Tighten the pinch bolts to 69-85 ft. lbs. (93-115 Nm). Outer tie rod ends. Tighten the nuts to 43-58 ft. lbs. (59-78 Nm). Sway bar links. Tighten nuts to 69-85 ft. lbs. (93-115 Nm). Hub retaining nuts. Tighten the hub nuts to 177-199 ft. lbs. (240-270 Nm). Front wheels. Tighten the lug nuts to 65-79 ft. lbs. (88-108 Nm).