1997 Jeep Grand Cherokee Logo

Related Topics:

A
Anonymous Posted on May 09, 2014

How to fix random misfire on 2000 jeep cherokee sport

5 Related Answers

RCL 42

  • 32 Answers
  • Posted on Dec 18, 2008

SOURCE: how do you replace a heater core in a 2000 jeep cherokee sport?

the entire air unit under the dash must come out. This requires that you remove the dash board center concle and steering column. Also on some models you must drain the AC system and then requires new Orings from Jeep. Would not do this without experience.

Ad

Anonymous

  • 104 Answers
  • Posted on Jan 01, 2009

SOURCE: 2000 jeep cherokee sport 4.0

I believe that year had distributorless ignition, instead it uses a form of coil on plug ignition system.

If you open the hood, stand at the front of the vehicle. Look to the left side of the engine, around the bottom of the valve cover (The valve cover is where the oil fill cap is. The oil fill cap is on top of the valve cover), at the bottom of the valve cover on the left side you will see a series of humps. Those series of humps is the coil packs, the coil packs are all in one long piece held down by three or four bolts.

Take out those bolts, gently pry up at the ends of the coil pack and it will eventually come out. You'll see on the bottom side the spark plug boots are attached to the coil pack. After you get the ignition coil pack off, you will see the spark plugs under where the coil pack came from, the boots on the coil pack sit directly on the spark plugs.

jamesjosephf

  • 4 Answers
  • Posted on Feb 15, 2009

SOURCE: 2000 jeep cherokee sport fuse diagram

unfortinately the fuse box is under the hood and there is no panel inside the 2000 cherokee or diagram, i had to buy an online manual to find out what fuse went where for my jeep but its not with me. You can just pull the fuses out one at a time and look at them - I know its a pain. It might be your window controll switch - mine is bad as well. It is a common problem for these cherokees especially over 100k, they wear out - I initally thought it was my fuse as well because the lights in the window switch didn't light up anymore - but it is my switch.

SuibeDude230

  • 27 Answers
  • Posted on Nov 18, 2009

SOURCE: replacing the Antenna on a 2000 Jeep Cherokee

this is how we did it for my Dads jeep his was a 98 so it should apply. let me know if it doesnt and i'll go break it down on my friends jeep 2000

Unscrew the antenna and the base flat base nut. Unfasten the mud guard in the wheel well enough to pull it aside and reach up to the antennae. Remove the kick panel to find where the cable enters the jeep.

Anonymous

  • 677 Answers
  • Posted on Jan 14, 2010

SOURCE: 1996 jeep cherokee sport. How to replace the

On a 96 model,the heater fan motor comes out through the engine bay.Take off the batt. leads.Undo the bolts and then remove the fan power lead.The fan has 3 bolts.It then comes out.Hope this helps

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 jeep grand cherokee is skipping and misfire codes

There are several different things that could make it misfire ! not just plugs ,does it have plug wires or is it coil on plug coils. Could have a coil breaking down. Does it do it in all driving conditions ? Idle , cruising speed ,under a light load and what codes .po300 random misfire or a specific cylinder misfire code ? P0306 cylinder #6 etc.
0helpful
1answer

2000 cherokee sport / ran good / had plugs changed & new valve cover with new gasket = picked it up , check engine lite on; scaned it ; comes up cycl 6 misfire everytime? [6cyl4.0]

Sounds like something may not have been reinstalled properly. I would take it back and have them recheck the job. I would check around that cylinder to see if something was left disconnected. Also check the spark plug gap of that plug, it may be incorrect.
0helpful
1answer

99 jeep grand cherokee code P302

That's a misfire on cylinder 2. Most likely problem is a bad spark plug or wire. I'd start by clearing the code though and see if it comes back. A random misfire can happen once and never come back. If it does, change the plug (do all of them), and you'll likely be fine.
0helpful
1answer

I have a Jeep Cherokee Sport 2000 6L, and i

under the hood there is sticker with what u need to know
0helpful
2answers

Jepp Cherokee 2000 4.0 L 123K miles, cylinder #6

try changing your crank senor. Get part from the dealer... My jeep was misfiring and changed OEM part and jeep rides good.
1helpful
2answers

2002 Jeep Grand Cherokee Lardo misfiring

You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.
Not finding what you are looking for?

245 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...