To remount a front parking sensor
SOURCE: cutout in the bumper
I know
nothing about Cadillac, but i've seen a similar thing on a Volvo, and it's
for towing the vehicule
SOURCE: head light removal
do you mean the whole unit... or just the bulb so you can replace it.... if you mean just the bulb... they are accessable from the engine compartment.... you will likely have to remove the battery to replace the one on that side.
Robert
SOURCE: my cadillac dts has bad vibrations over 50 mph ,
very well could just be a bad tire. I have replaced brand new tires straight from manufacturer you should check for a bad wheel or balance of tire and perferabley somewhere where they do a phase match balance.
SOURCE: headlight
Well according to my mitchell manuel you don't have to.here is the procedure.
1. open the hood.
2.Remove the push-pin retainer's that secure the top of the upper facia and grill assembly to the upper tie bar to allow the upper facia and grill assembly to flex forward.
3. remove ther bolt and push-pin retainer that secures the top of the headlight assembly to the upper tie bar.
4. Gently pull the upper facia and grill assembly forward to access the bolt on the inboard side of the headlight assembly
5. Pull the headlamp assembly straight out to disengage the the snap in retainer at the lower outboard back surface of the assembly. Turn the assembly so that the inboard assembly clears the front facia.
6. pull the assembly out and away from the veh.From there you'll be able to access bulbs.
be careful not to touch the bulb with fingers or oil in skin will blow bulb.
Good luck.
?€¢
Disconnect the electrical connectors.
530 views
Usually answered in minutes!
×