SOURCE: how do I replace a fan belt on C280 model with air conditioner
You find a 17 mm bolt under the belt or a 15 mm bolt in the middle of the tension pulley. If you undo the bolat this will
release the belt tension.
To remove the belt turn the bolt by slipping a 4' pipe
over the socket wrench handle.
Use a wrench as a lever to slide out the belt. Put the new belt last on the idler pulley that contacts the belt only on the smooth
side.
Do not unscrew the Button Torx bolt in the center of the tension pulley, it is not needed.
SOURCE: 1998 Mercedes C280 2 Sensor gone bad. Where are the sensors...
sensor located in the exhaust system somewhere they just unscrew to remove
SOURCE: how do you time a 1995 Mercedes C280 inline 6 cyl?
hi,pls. remove the cylinder head cover,try to rotate the crankshaft on ot position,then look the hole 5mm in intake and exhaust sprocket,install 2 pcs. of 5mm pin with align on surface of cylinder head,ot on crankshaft pulley and two sprocket lock in the surface of head ,you have a104.941 engine,ty
SOURCE: where's turn signal switch? on c280 1994 mercedes
The switch is the stalk assembly on steering column. The hazard switch is the relay(FLASHER). To replace switch r&r LF under dash and unplug 2 connectors at base of steering column(electrical). You will need a long t20 socket to remove airbag and then a 10mm allen to remove steering wheel. There are a series of screws to remove the c.c. switch steering airbag contact and blinker switch. I would recommend replacing the hazard switch first unless you are certain that the blinker switch is bad.
SOURCE: ABS light intermittent on 1995 Mercedes C280
hello,good day,try to clean your abs sensor and rotor,apply with wd 40 then cean with compress air,also check electrical connection,for your radio please recheck the power supply specially the parking light wiring,ty
180 views
Usually answered in minutes!
If its the bulb you mean open the bonnet or hud (usa) where the head lights are the indicators are at the very side of them there is a plastic clip thats part of the unit this part is clipped onto the wing push the clip to relise the unit and the whole indicator comes out change the bulb and put it back into the slot making sure the plastic clip goes back into the hole
×